[. . . ] GPSMAP® 4000/5000 Series owner's manual © 2008 Garmin Ltd. (913) 397. 8200 or (800) 800. 1020 Fax (913) 397. 8282 Garmin (Europe) Ltd. Liberty House Hounsdown Business Park, Southampton, Hampshire, SO40 9RB UK Tel. +44 (0) 870. 8501241 (outside the UK) 0808 2380000 (within the UK) Fax +44 (0) 870. 8501251 Garmin Corporation No. [. . . ] · Set Fuel Level--Select to specify the total fuel in your tanks. Viewing Video Your unit can display video if you connect it to a video source using the supplied video cable. See the GPSMAP 4000/5000 Series Installation Instructions for details. Select Menu to set up the following: · Source--selects the video device (1 or 2) to use to display video. If you have two video sources and want to alternate between the two, select Alternate to define the amount of time each video is displayed. · Aspect--switches between the standard aspect ratio and a stretched aspect ratio. The video cannot be stretched beyond the dimensions provided by the connected video device. Because of this, the stretched video may not fill the entire screen of the GPSMAP 4012/5012. · Brightness--adjusts the brightness of the video feed up or down, or select Auto to allow the unit to automatically adjust the brightness. · Saturation--adjusts the color saturation up or down, or select Auto to allow the unit to automatically adjust the saturation. · Contrast--adjusts the contrast up or down, or select Auto to allow the unit to automatically adjust the contrast. · Standard--selects the video format used by the source (PAL or NTSC). Select Auto to let the unit automatically select the source format. WARNING: Do not attempt to operate or watch video input while operating or navigating your boat. Operating or watching the video input while the boat is moving could cause an accident or collision resulting in property damage, serious injury, or death. VieWinG information 28 GPSMAP® 4000/5000 Series Owner's Manual Configuring the Chartplotter Configuring the Chartplotter Use the Configure screen to configure unit settings. Configuring System Settings To change general system settings from the Home screen, select Configure > System. (If you set the unit into a Store Demonstration mode during the initial unit setup, this setting is named Demo. ) Language--select the on-screen language. Auto Power Up (GPSMAP 4010 and GPSMAP 5015 only)--turn Auto Power Up On or Off. When On is selected, the chartplotter will automatically turn on whenever power is applied, unless the chartplotter is turned off with the Power Key before power is lost. Beeper/Display--select Beeper to set when the unit makes audible sounds. GPS--view GPS satellites, turn WAAS/EGNOS on or off, select the source of GPS signals, and set the speed filter to On, Off, or Auto. The speed filter averages the speed of your boat over a short period of time for smoother speed values. System Information--view system information, restore factory settings, view the status of networked devices, and display the event log. Overlay Numbers--view or edit the options for Wind (Apparent Wind or True Wind) and Next Turn numbers (Distance or time) for routes. ConfiGUrinG the Chartplotter Changing Units of Measure To change units of measure from the Home screen, select Configure > Units. System Units--global setting that defines individual units of measure at the same time. [. . . ] Water Temperature Alarm--(temperature sensor/ transducer) the water temperature has entered or left the user-defined water temperature alarm zone. Warning: Auto-guidance route starting position moved due to safe depth settings--(BlueChart g2 Vision) autoguidance has calculated the route, but the starting point has been moved to deeper water. Warning: Auto-guidance route ending position moved due to safe depth settings (BlueChart g2 Vision) autoguidance has calculated the route, but the end point has been moved to deeper water. Waypoint Memory is Full, Can't Create Waypoint--the User Waypoint memory is full. [. . . ]